FLATpack R3, can dim also led lamps
flatpack3 voor 
FLATpack R3 is a DMX512 steered, 16-fold short circuit proof dimmer, based on IGBT's. The maximum load for each dimmer channel is 300[W] , the total pack load is 3500[W].
FLATpack R3 is designed to drive ohmic-, capacitive- and some inductive loads, which makes it suitable to dim almost ALL kind of light sources. Smoothly it will dim lamps with ring-core transformers as well as lamps with electronic transformers, standard halogen lamps, LED lines, multi-LED bulbs and, just new on the market, 230volt Acriche LEDs. Also because of the very small form factor  it is good choice to dim the lighting in an DMX steered environment like laboratories for lighting design, exhibitions, museums, disco's, architectural lighting, puppet theatre and objects of art.
On the front panel you can set the DMX-address and select a control curve for each dimmer with the aid of a three digit led display and some push buttons. All settings are stored permanently in memory.
Easy installation: with five 8-pole WAGO cage clamp connectors (included in the delivery). Easy use: all instructions on front panel.
FLATpack is fully digital- and a 100% printed circuit board design; there are no internal wirings. It comes in a flat (height=49[mm]) aluminium housing.
 
Features:
  • 16 dimmers in one package
  • Meant for almost all kinds of load, included 230[V] multi-led lamps and Acriche LED's
  • Output can be set parallel
  • Outputs internal protected against overload and short-circuit 
  • 9 different control  curves selectable per dimmer: smooth 11-bits fade
  • 3-digit led display for setting and displaying the DMX address and control curves
  • DMX-in/through on 5-pole Neutrik PCB mounted connectors (no internal wiring)
  • DMX512 input galvanic isolated, fail save for open input and protected against over voltage. 
  • Led indication for DMX512 present
  • Over temperature sensing per dimmer channel, with warning led and read out on led display
  • Temperature control by means of a electronically controlled blower
  • Blower failure check
Specifications:
  • Dimmer channel load: maximum 300[W], ohmic inductive and capacitive load (for R2 maximum 220[W])
  • For each channel choice between leading- or trailing edge phase control or a mix of these.
  • Total package load 3500[W] @ max. T-environment=32[Celsius]
  • Outputs on five 8-pole WAGO connector's serie 231. Cable part with strain relief will be included.
  • Mains inlet: 3-pole 16[A], 230[V] Euro connector. Cable part will be included.
  • Dimensions 416x140x47[mm]
  • Weight 1.75[kg]
flatpack achter
 References FlatpackR2/R3: Manual: Accessories: 
  • 19inch brackets-set 
  • wall stand off straps 

Related products: